MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
4
Set pockets and pocket flaps.
1
Finished appearance. The pockets
and pocket flaps shall be set
without twists, gathers, puckers,
pleats or raw edges. The
stitching for the raised edge of
the flaps shall conform to
stitching for setting the pockets.
The side edges of the pockets
shall not be exposed beyond the
sides of the flaps. The pocket
and pocket flaps on the left and
right side, respectively, shall be
in horizontal alignment with each
other. The front edge of the
upper pockets, pocket flaps, and
pleats shall be in parallel
alignment with front edge of coat
when buttoned. The top of the
breast pocket flaps shall be
perpendicular to the front edge of
coat when buttoned. The point of
the upper pocket flap shall be at
the center of the pleat on the
upper pockets. The center of the
pleat on the upper pockets shall
be aligned as accurately as
possible with the waist darts in
the fronts. The top edge of the
bottom pocket flap shall be
parallel with the waist seam line,
and the front edge of the flap
shall be in line with the front
edge of the upper pocket. The
lower front corners of the bottom
pocket shall be 3/8 inch further
back towards the side seam.
Pockets and pocket flaps shall
conform to the measurements in
Table III.
NOTE: The breast pocket and flap
marker (template) constructed by
the manufacturer shall be made to
ensure that the top of the breast
pocket flaps finish perpendicular
to the front edge of the coat and
the front edge of the breast patch
pocket shall finish in vertical
alignment with the front edge of
the lower flap.
45
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business