MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Make sword slit and attach
4
3
buttonhole tab (see Figures 6 and
7). (cont'd)
a. Mark left front for 2 inch
long sword slit in waist seam.
The back end of the sword slit
shall be 1/2 to 5/8 inch in front
of underarm seam.
b. Topstitch the front for 2
301
OSf-1
12-16
A
A
inches at the marks for the sword
(silk)
(silk)
slit 1/16 inch below waist seam.
The stitching shall be through the
allowance of the waist seam but
not through the pocket stay. The
lower pocket stay material shall
be trimmed away from the sword
slit opening.
c. Tack across waist seam at each
301
SSa-1
12-16
A
A
(silk)
(silk)
end of the topstitching to prevent
seam from opening when sword slit
is cut. The tacks shall be 1/8
inch long, 1/16 inch on each side
of seam.
d. Mark tab 1-3/4 inches from
301
LSd-1
12-16
A
A
bottom edge. Cut waist seam open
(silk)
(silk)
for sword slit and position tab on
outside of front with top end
inserted through slit. Align mark
on tab with upper folded edge of
slit. Topstitch front 2 inches
along waist seam 1/16 inch above
opening, stitching through seam
allowance and tab, and securely
tacking each side of the tab to
the front at the opening. The
basic fabric side of the tab shall
be towards the outside of the
coat.
48
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business