MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
5
Bind bottom turnup.
(cont'd)
3
a. Bind the raw edge of the
301
BSb-1
10-14
A
A
bottom turnup with bias binding,
turning under the outside raw edge
of binding only and catching the
turned under portion in the
stitching 1/16 inch from the inner
folded edge. The binding shall
extend from the back edge of the
front cutout to the edge of the
vent at the center back.
5
Baste facing-lining assemblies to
4
fronts.
a. Position the right and left
301
(Commer-
facing lining assemblies on the
or
cial)
outside of the respective fronts
Hand
and baste along the breakline,
distributing the fullness in the
breast area. Continue to base
along the front and bottom edges.
Baste from the top and front edge
of lapel down to the lower end of
lapel, working the fullness
towards the center of lapel.
5
Join facings and fronts with
5
polyester/cotton tape.
a. Join the facings to front 3/16
301
SSab-1
10-14
A
A
inch from top and front edges of
lapels and front and bottom edges
of coat, with a 1/2 inch wide
polyester/cotton tape positioned
on the interlining side of fronts
and caught in the stitching.
b. The polyester/cotton tape
shall extend from 1/2 inch to the
back of the lapel notch to 1-1/2
to 2 inches beyond back edge of
facing, except the tape is not
required along the step of the
right front. The tape shall be
sewn with normal tension along the
top and front edges of the lapel
and with slight tension along the
front edge of the coat.
54
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business