MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
4 Set belt loops (see Figure 8).
4
Finished appearance. The belt
loops shall finish vertically
straight and shall be positioned
1/4 inch in from the back end of
the lower flap and perpendicular
to the lower flap. The belt loops
shall measure 2-1/2 + 1/8 inches
along from top to bottom folded
edges. The underloop for the belt
fastener shall have an opening of
not less than 1-3/4 inches.
a. Position the 5-1/2 inch long
Bartac
28 per
B
B
belt loop on the left front, 1/4
k
bartack
(silk)
(silk)
inch in from back end of the lower
(min)
pocket flap, with one end
approximately 1 inch above the
waistseam. Bartack the loop to
the front 1/8 inch from the end of
the loop. Bartack the loop to the
front at the top edge of the lower
pocket flap, 1/4 inch from the
backend of the flap to form the
underloop for the belt fastener.
Turn under the top end of the loop
to the front 1/8 inch from the
folded edge, catching the turned
under portion of the loop in the
stitching (see Figure 7).
b. Position one end of the 3-1/2
Bartac
28 per
B
B
inch long belt loop on the right
k
bartack
(silk)
(silk)
front and bartack the loop to the
(min)
front at the top edge of the lower
pocket flap 1/4 inch from the back
end of the lower pocket flap.
Turn under the top end of the loop
and bartack the loop to the fronts
1/8 inch from the folded edge with
loop caught in the stitching.
4 Interline fronts.
5
a. Position the left and right
301
(Commer-
fronts on the respective coat
or
cial)
front interlining and baste along
Hand
the top edge of the upper pocket
flap on the outside.
49
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business