MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
3 Press center back seam and vent
6 lining.
a. Notch the top end of the right
vent diagonally from the juncture
point of the vent and the center
seam allowance of the right back
part to lower end of the stitching
for the center back seam.
b. Spread the center back seam
open and press flat with a heated
pressing iron.
3 Baste and stitch vent lining.
7
Finished appearance. The folded
edge of the lining shall extend
beyond the center seam allowance
of the right backpart.
a.
Baste vent lining to coat.
101
or
Hand
b. Stitch the upper part of vent
301
SSa-1
10-14
A
A
lining to center back on each side
(silk)
(silk)
of the seam allowance 1/8 inch
from seamed edge of lining. Turn
coat on the outside.
c. Stitch and backstitch through
301
SSa-1
10-14
A
A
all plies, across the top end of
(silk)
(silk)
vent, through the vent lining,
from the back center seam to the
edge of the vent.
3 Seam reinforcement stay to armhole
8 and shoulder.
Finished appearance. The cotton
and polyester twill reinforcement
stays shall be sewn to the armhole
and shoulder edges of the fronts
without gathers, puckers or
pleats.
42
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business