MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
3 Assemble inside pocket on lining
1 and facing. (cont'd)
j. Turn down the back part of the
301
SSa-1
10-14
A
A
pocket and seam the front and back
together approximately 1/2 inch
from raw side and bottom edges,
catching the tongue notch at each
end of the pocket opening in the
stitching and securely backtacking
each end of the tongue notch.
Continue to stitch across top of
pocket adjacent to top piping
seam, catching twill stay in the
stitching and closing top of
pocket.
k. Stitch the lining, on the
301
SSv-1
10-14
A
A
outside, to the diagonal extension
of the pocket stay from the
armhole end of the pocket opening
to the armhole. Tacking of the
pocket stay to the canvas only is
permitted.
l. Notch top of polyester and
103
SSm-1
4-6
A
cotton pocket at front edge of the
or
full width of seam allowance and
306
SSm-1
4-6
A
A
blindstitch inner ply of pocket to
facing (see 80.c for alternate
operation).
m. In the finished coat, the
width of the pocket opening shall
be 5 + 1/4 inches for all sizes
and shall not extend into the
facing more than one inch nor
extend into the armhole. The
depth of the pocket shall be not
less than 6 inches.
n. Sew the instruction label to
301
SSa-1
10-14
A
A
the outside of the right pocket
facing, centered, 1/2 inch below
pocket opening, with a single row
of stitching 1/16 inch from each
edge.
38
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business