MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Seam facing to front lining.
3
0
(cont'd)
b. Seam the front edge of the
301
SSa-1
10-14
A
A
lining to the back edge of the
facing 3/8 inch from the edge,
matching the notches in the lining
to form a horizontal pleat. The
pleat shall face down.
c. Press the facing lining seam,
the pleat, the underarm dart, and
the bottom edge of the lining
smooth and flat with a heated
pressing iron, with the raw edges
of the underarm dart toward the
side.
3
Assemble inside pocket on lining
1
and facing.
a. The inside pocket shall be
made of one piece of
polyester/cotton twill cloth with
a facing of rayon lining at the
horizontal piped pocket opening.
b. Position the rayon facing on
301
LSd-1
10-14
A
A
the pocket material with notches
(each
matching. Turn under the top and
turned
bottom edges, respectively, of the
edge)
facing and seam the facing to the
SSa-1
pocket 1/16 to 1/8 inch from the
(each
folded edges with the top edge of
selvage
identification label centered and
edge)
caught in the stitching at the top
edge of facing. Selvage edge need
not be turned under.
c. Stitch the remaining three
301
SSa-1
10-14
A
A
sides of label to pocket 1/16 inch
from each edge.
d. Mark the right facing and the
front lining, with the pocket
marker furnished, for the position
of the pocket opening.
36
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business