MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Make under collar.
1
(cont'd)
7
g. Quilt the interlining to the
103
SSm-1
4-6
A
A
under collar with 4 to 5 rows of
blind stitching.
h. Press under collar smooth and
flat with a heated pressing iron
or pressing machine.
i. Stitch under collar to
301
SSa-1
10-14
A
A
interlining 1/2 + 1/8 inch from
top and side edges.
1 Assemble top collar and under
8 collar.
Finished appearance. The collar
shall be uniform in appearance and
shall finish smooth and flat
without twists, gathers, puckers,
pleats or raw edges (top and
sides). The felling shall not be
too tight or loose and the collar
material shall be securely caught
in the stitching. The eyelets
shall be well worked with the
purling on outside of the collar
and shall finish with a 1/8 inch
diameter opening.
a. Position top collar between
under collar and interlining with
the upper edge abutting the under
collar interlining seam and with
notches aligned.
b. Join top collar to under
304
LSa-1
8-10
A
A
collar at top edge with zig-zag
stitching, properly distributing
the fullness between the notches.
The zig-zag stitching shall extend
to the end of the collar.
c. Turn the under collar inside
301
SSa-1
10-14
A
A
on the top collar and stitch the
ends with a 1/8 inch seam.
d. Trim and turn the top collar
to the outside, forcing out the
ends.
29
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business