MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
1
Attach snap fasteners (see Figure
2
5).
Finished appearance. The snap
fasteners shall be securely
attached to the belt. On the
finished coat, the belt ends shall
be fastened without misalignment
or gap. The stitching on the
socket part of the snap shall not
catch the outer part of the belt.
1 Attach snap fasteners (see Figure
2 5). (cont'd)
a. Sew the socket part of the
Hand
3-4
C
snap fastener to the inside point
(double
(silk)
of the belt 1/2 to 5/8 inch from
or
thread)
the point. The stitching shall be
101
21 per
0
tacked off with not less than two
fastene
(silk or
stitches.
r
nylon)
b. The stud portion of the
fastener shall be engaged in the
socket portion for ultimate
attachment by user.
1
Make upper and lower pocket flaps.
3
Finished appearance. The pocket
flaps shall be uniformly stitched
and shall finish smooth and flat,
without twists, gathers, puckers,
pleats or raw edges and shall be
uniform in shape and size in
accordance with the finished
pocket flap shaper. The seamed
edges, the corners and point of
the flaps shall be well worked out
and the rayon lining shall not be
visible on the outside of the
flaps. The button- holes shall be
clean cut, well made, properly
positioned, well worked over gimp
to fit a 27-line insignia button,
and stitching shall be securely
caught in the basic material. The
gimp shall be pulled through to
the underside of the buttonholes
and the purling of the buttonholes
shall be on the outside of the
flaps.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business