MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
6
Seam belt (see Figure 5).
Finished appearance. The belt
shall be uniformly stitched and
shall finish smooth and flat
without twists, pleats, gathers,
puckers, or raw edges.
a. The belt shall be made of two
plies of basic material,
interlined with cotton buckram
interlining.
Seam belt (see Figure 5).
6
(cont'd)
b. Place the interlining material
301
EFn-2
10-14
A
A
between the basic materials and
(silk)
(silk)
seam together uniformly 1/8 inch
from upper and lower edges, with
the raw side edges of basic
materials turned in and caught in
the stitching. The stitching
shall extend from one end of belt
to approximately 1-1/4 inches from
the opposite end.
7
Close ends of belt (see Figure 5).
Finished appearance. The pointed
end of the belt shall be well
formed with turn-in edges securely
caught in the stitching.
a. Turn back the under and top
ply of basic material at the top
and bottom unseamed edges of the
belt and trim the interlining
approximately 1 inch back from the
end.
b. Fold the top and under ply of
301
SSa-1
10-14
A
A
the unseamed end of the belt half
lengthwise face to face, and
stitch each ply respectively 1/8
inch from the end.
c. Turn the ends of the top and
301
SSc-1
10-14
A
A
under ply, working out the points.
(silk)
(silk)
Position the two points even and
stitch together 1/8 inch from
folded and turned edges, closing
the ends and forming a point at
the center of the finished end.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business