MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Make lower pocket.
1
5
Finished appearance. The binding
shall be uniformly stitched and
shall not be tight or full causing
puckers, gathers or pleats; the
basic material and both edges of
binding shall be securely caught
in the stitching. The pockets
shall be uniform in shape and size
in accordance with finished pocket
shaper. The pockets shall be
lined with polyester/cotton twill
cloth (see 3.3.3).
a. Place the polyester/cotton
301
SSa-1
10-14
A
A
twill lining on the underside of
pocket and seam together along the
top, sides, and bottom 1/8 to 1/4
inch from raw edges.
b. Bind the upper edge of the
301
BSc-1
10-14
A
A
pockets, including the lining,
with 7/8 inch wide bias binding.
Top edge of the binding shall be
turned under and caught in the
stitching 1/16 inch from the inner
folded edges of the binding.
c. Mark the pockets in accordance
with finished shaper.
d. Seam lower corners of pockets
301
SSa-1
10-14
A
A
3/8 inch from the edges.
e. Spread open the corner seams
of pockets and press smooth and
flat with a heated pressing iron.
f. Trim corners and turn pocket
301
OSf-1
12-16
A
A
working out the corners
or
(silk)
(silk)
completely. Turn under side and
101
(Commer-
(Commer
bottom edges of pockets at the
or
cial)
-cial)
mark to form bellows and baste
Hand
along the folded edges. Edgestich
uniformly 1/8 inch from folded
edges.
g. Press entire pocket smooth and
flat with heated pressing iron or
pressing machine, evenly
increasing the edges.
26
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business