MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
2
Seam sleeve at backarm.
(cont'd)
1
b. Spread open the sleeve and
cuff seams and press flat with a
heated pressing iron.
2
Tack cuff to sleeve.
2
a. Turn the cuff outlet to the
101
(Commer-
inside, in accordance with
or
cial)
notches, against the bottom end of
Hand
(Commer-
the sleeves and baste along the
cial)
turned edge of cuff.
b. Tack the raw edge of the cuff
103
SSm-1
4-6
A
A
to the body of the sleeve with
blind stitching.
c. On the finished coat, the
length of the cuff shall be 3-1/4
+ 1/4 inches at the front and back
creased edges and 6 + 1/4 inches
at the point.
2
Seam sleeve linings.
3
Finished appearance. The sleeve
lining shall be uniform in
appearance, uniformly stitched and
shall finish smooth and flat
without twists, gathers, puckers
or pleats. The seams shall start
and finish evenly.
a. Position the top and under
301
SSa-1
10-14
A
A
sleeve lining pieces in accordance
or
with notches on pattern and join
401
SSa-1
10-14
A
A
the forearm and backarm
respectively, with a 3/8 inch
seam, continuously from top to
bottom on each seam.
NOTE: The seams of the sleeve
lining shall be finished on the
inside of sleeve linings.
2
Assembly sleeve and sleeve lining.
4
Finished appearance. The sleeve
linings shall be properly
positioned and seamed to sleeve
without twists, gathers, puckers
or pleats.
32
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business