MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
3 Bind backs.
2
Finished appearance. The binding
shall be uniformly stitched, shall
not be tight or full causing
puckers, gathers or pleats and the
basic material and edges of
binding shall be caught in the
stitching. The outside raw edge
only of the binding shall be
turned under and caught in the
stitching.
a. Bind the raw side edge of the
301
BSb-1
10-14
A
A
left and right backparts,
respectively, with bias binding,
from the top edge of backparts to
the top end of the vent. The
outside raw edge only of the
binding shall be turned under and
caught in the stitching 1/16 inch
from the inner folded edge. When
binding the left backpart,
continue to bind the raw edge of
the vent for the left back part
from the top to the bottom end.
The binding is not required along
the top edge of the vent.
b. Bind the raw side edge of the
301
BSb-1
10-14
A
A
left and right backpart,
respectively, with bias binding
from the top to the bottom edge of
the coat. The outside raw edge
only of the binding shall be
turned under and caught in the
stitching 1/16 inch from the inner
folded edge.
3 Bind facings.
3
Finished appearance. The binding
shall be uniformly stitched, and
shall not be tight or full causing
puckers, gathers, or pleats. The
basic material shall be securely
caught in the stitching. The
binding shall extend from the
bottom edge of facing to not less
than one inch above bottom
finished edge of lining.
39
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business