MIL-DTL-21083E(MC)
3.3.18.1.Identification label. The identification label shall
conform to type VI, class 1, of DDD-L-20 and shall measure not
less than 2-1/2 inches wide by 1-1/2 inches long. The content
and format shall be as follows:
Nomenclature:
Contract number:
Name of contractor:
Wool Products Act information
DRY CLEAN ONLY
NOTE: Size of characters for "Name of contractor" shall be
minimum 8 points (Approximately 3/32 inch).
3.3.18.2.Size label. The size label shall be type VI, class 2 of
DDD-L-20 and shall measure not less than 1-1/2 inches by 1 inch.
The label shall consist of the numerical size designation
specified in 1.2 followed by the letters S, R, L, or XL for
Short, Regular, Long and Extra Long, and the stock number as
shown by the following example:
40R
3.4. Design. The coat shall be the U.S. Marine Corps design
shown on Figures 1 through 8, a four-button, single-breasted,
quarter-lined coat with separate belt, having a skirt type front
with side body pieces, waist seam and waist darts, upper patch
pockets and lower bellow pockets with worked eyelets for
detachable insignia buttons and with flaps to button, a two-piece
back with lined vent, ornamental sleeve cuffs, one inside breast
pocket with horizontal piped opening, shoulder straps to button,
and a roll collar with worked eyelets and notched lapels. Coats
shall have a sword slit in waist seam at left side with a lined
tab on inside to button.
3.5. Patterns. Standard patterns will be furnished to the
contractor by the Government. The standard patterns shall not be
altered in any way and shall be used only as a guide for cutting
the contractor's working patterns. The contractor's working
patterns shall be identical to the standard patterns. The
standard patterns provide 3/16 inch allowance for seams at the
edges of the lapels, front edges of coat, and for pocket flap and
shoulder strap seams; 3/4-inch allowance for side seam; 5/8-inch
allowance for center back seam; and 3/8-inch allowance for all
seams, except as otherwise specified in Table I. Standard
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business