MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
4 Interline fronts. (cont'd)
5
b. Tack the top edge of the upper
301
(Commer-
pocket stay and the front end of
or
cial)
the upper and lower pocket stay to
Hand
the coat front interlining. The
front end of the stays shall be
tacked as close to the side edges
of the pocket flap as possible.
301
(Commer-
c. Baste the interlining and
fronts together starting
or
cial)
approximately 1-1/2 inches above
Hand
the top edge of upper pocket flap
and baste along the center of the
upper pocket flap and pocket,
along the waist dart to the top
edge of the lower pocket flap, and
then diagonally across the front
corner of the lower pocket flap to
the front edge of the lower
pocket. From that point, continue
to baste along the front edge of
the pocket to the bottom of the
coat.
d. Baste along the breakline of
301
(Commer-
lapel and along the front edge
or
cial)
down to the bottom of the coat.
Hand
e. Baste across the shoulder,
301
(Commer-
allowing room for setting the
or
cial)
shoulder pad, and working the
Hand
fullness towards the armhole.
Baste along front of armhole and
down the back edge of the
interlining.
4 Baste bridle tape to lapel.
6
a. Position the 5/8 inch bridle
tape adjacent to and behind the
breakline from the gorge to 1 to
1-1/2 inches from lower end of
lapel.
50
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business