MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Join facings and fronts with
5
5
polyester/cotton tape. (cont'd)
c. Fell inside edge of 1/2 inch
103
SSm-1
4-6
A
A
wide stay tape to the coat front
interlining from top end of tape
to the bottom edge of interlining.
d. Remove all basting stitches,
trim lower front corner of the
facings and corner of lapels, and
notch the lapels for proper
turning.
e. Press edges flat and smooth
with a heated pressing iron. Edge
seam is to be pressed open.
5
Baste front and bottom edge of
6
coat.
a. Turn the facing-lining
assemblies to the inside of the
fronts, completely working out the
corners of the lapel. Turn up the
bottom of the coat, lapping the
facing on the bottom turnup and
completely working out the front
corner.
b. Baste along the top and front
101
(Commer-
edges of the lapels, the front
or
cial)
(including the step of the right
Hand
front) and finished bottom edges
of the coat, working the seams to
the edge of the coat.
5
Fell bottom turnup.
7
a. Fell the bound edge of the
103
6-8
0
bottom turnup to the fronts and
or
(silk)
6-8
backs blind stitching.
306
0
or
(silk)
Hand
6-8
0
(silk)
55
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business