MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
Fell facings to fronts and tack to
5
9
interlining. (cont'd)
d. Tack the back edge of the
103
SSm-1
4-6
A
A
right facing to the front
or
interlining only, with one row of
Hand
8-10
C
blind stitching from not more than
(silk)
3 inches from shoulder edge to not
more than 1 inch above inside
pocket opening. Continue the
tacking along the outer ply of
inside pocket seam allowance the
length of the pocket (see 80.c for
alternate operation).
Baste yoke lining to back.
6
0
a. Position and baste the
301
(Commer-
one-piece rayon yoke lining to the
or
cial)
inside of the back along the
Hand
center pleat, armholes, shoulder
(allowing room for shoulder pad)
and bottom edge of the yoke.
6
Baste and fell front lining.
1
a. When necessary, trim the back
end of lower pocket stays away
from the side seam.
b. Tack the upper back corner of
Hand
4 per
(Commer-
inside pocket to coat front
or
(min)
cial)
interlining.
Machin
e
c. Fold the front lining, forming
the chest pleat at the armhole.
Continue to baste across the pleat
and toward the lower edge of
armhole, along the side seam and
across the bottom edge of lining.
The folded edge of the chest pleat
on the outside of the lining shall
be towards the bottom.
d. Turn under the back edge of
Hand
(Commer-
front lining and baste to coat,
or
cial)
lapping the folded edge over the
301
side seam and yoke lining and
basting to allow room for felling
of side seam lining.
57
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business