MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
7
Tack armhole and stitch
7
sleeve-head pads.
Finished appearance. The armhole
shall not be distorted or puckered
due to stitching the sleeve-head
pads and linings at the armhole.
a. Position the sleeve-head pad
on the sleeves with the folded
edge of the pad approximately 1/8
inch back from the raw edge of the
armhole seam, and with the front
end of the pad matching the notch
in the fronts.
Tack armhole and stitch
7
7
sleeve-head pads. (cont'd)
b. Stitch the sleeve head pad to
301
SSa-1
4-6
30/3
30/3
the sleeve from end to end through
the armhole sleeve seam allowance,
1/8 inch from the folded edge of
the pad, catching the armhole end
of the stay for the upper pockets,
the front and yoke linings,
shields at base of armhole and
shoulder pad in the stitching.
Continue stitching the linings
around the remainder of the
armhole, trimming away the excess
material.
7
Fell collar to coat.
8
a. Fell the lower edge of the
Hand
entire length of under collar to
or
the fronts and backs.
Machin
LSa-1
8-12
C
e
(silk)
or
Hand
type
fellin
LSa-1
8-12
0
0
g or
(silk)
(silk)
306
b. Fell the folded edge of the
Hand
8-10
C
top collar to the coat from gorge
(silk)
seam to gorge seam, catching the
top edge of the size label and the
ends of the coat hanger in the
stitching.
65
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business