MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
7 Fell linings. (cont'd)
9
NOTE: Alternate construction:
When the alternate construction to
fell the armhole lining by machine
is used it consists of leaving an
opening between the notches of the
forearm sleeve lining seam.
Stitching the lining to the
armhole on the inside from front
sleeve notch of sleeve to back arm
seam across under sleeve (301
stitch) utilizing the forearm
sleeve opening stitching the top
sleeve lining to the armhole on
inside by felling machine from
front sleeve notch to back arm
seam across the crown of top
sleeve lining. Close the
previously left open forearm seam.
b. Stitch the sleeve lining by
301
SSa-1
10-14
A
A
machine to the armhole on the
or
inside from forearm seam to
Hand
8-10
C
backarm seam across under sleeve,
(silk)
and fell the balance of the sleeve
lining to the armhole by hand.
The forearm and backarm seams of
sleeve linings shall be matched.
-or-
c. Machine stitch the lower
Machin
8-10
C
portion of the armhole as required
e
(silk)
in 79.b. The remaining upper
Dupli-
portion of the armhole shall be
cated
felled using machine duplicated
hand felling with stitching placed
over the folded edge of sleeve
lining with the fullness
distributed along the bias front
of armhole and back of armhole
from shoulder seam area to 1 to 2
inches below backarm seam.
NOTE: It is required that the
machine duplicated hand stitching
shall be equal to or better than
felling stitches made by hand.
67
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business