MIL-DTL-21083E(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
BOB/LPR
O
a. Stitch the side and top edge
301
SSb-1
10-14
A
A
(Collar
(silk)
(silk)
of collar, top and front edge of
the lapels, front edges of the
)
coat (including the step of the
SSe-2
right front), and continue the
(Lapels
front
stitching along the bottom edge of
the coat the width of the facings.
and
bottom
edge of
coat
(shows
finishe
d
seam))
b. The stitching shall be
uniformly 1/8 inch from the edge.
7
Set sleeves.
4
Finished appearance. The sleeves
shall be properly and uniformly
set and the fullness at the
armholes shall be properly
distributed. The armhole sleeve
seam shall finish smooth and flat
without twists, puckers or pleats.
The armhole shall not be stretched
or distorted due to pressing.
a. Position sleeves on outside of
coat at the armholes, with back
arm seam of sleeve matching notch
in the back, and with notch in top
sleeve and fronts matching.
b. Join the sleeves to the coat
301
SSa-1
10-14
A
A
with a 3/8 inch seam, distributing
or
the fullness in accordance with
401
SSa-1
10-14
A
A
good manufacturing practice and
catching the ends of the shoulder
straps in the stitching.
63
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business