MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
42 Seam reinforcement stay to armhole and
shoulder.
Finished appearance. The polyester
twill reinforcement stays shall be
sewn to the armhole and shoulder edges
of the fronts without gathers,
puckers, or pleats. The top end of
the armhole stay and lower edge of the
shoulder stay shall form a right angle
at the armhole without the stays
overlapping each other.
a. Seam the 3/4 inch wide stays to
301
SSa-1
10-14
A
A
the underside of the fronts along the
shoulder edge and upper front edge of
the armhole, respectively 1/8 inch
from the outer edges.
43 Tape armholes.
a. Sew 1/4 inch wide stay tape around
301
SSaa-1
10-14
A
A
the armhole from a point 1 to 1-1/2
or
inches above notch on the fronts to
401
3/4 to 1 inch from shoulder edge on
the back.
b. From the front notch to
301
SSaa-1
10-14
A
A
approximately 1-1/2 to 2 inches back
or
of the underarm seam, the tape shall
401
be stitched with slight tension and
from this point up to 1-1/2 to 2
inches above the notch on the back,
the tape shall be held taut while
stitching and gathering 1/4 to 3/8
inch fullness.
44 Press armholes and shoulder blades.
a. Press the armhole tapes, the
shoulder blades and the front smooth
and flat with a heated pressing iron
or suitable type pressing machine.
45 Shape fronts.
a. Mark and shape the front edges of
the coat. Dress the left front on a
line running from the top notch to the
waist seam 1 inch from the front edge.
Continue on a straight line from the
waist seam to the notch at bottom as
indicated on the pattern.
44
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business