MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
35 Set pockets and pocket flaps.
(cont'd)
d. Turn down the flaps and topstitch
301
LSq-2
12-16
A
A
the flaps 1/8 inch down from the
(b)
(silk)
(silk)
raised edge.
e. Position the upper pockets in
301
LSd-1
12-16
A
A
accordance with the marks and seam to
(silk)
(silk)
the front uniformly 1/8 inch from the
side and bottom edges. The top
corners of the pockets shall be
securely tacked through the polyester
twill stay pieces.
f. Position the lower pockets in
301
SSa-1
10-14
A
A
accordance with the marks on the
(each
pattern, lower edge to be 1-1/4 inches
edge)
above the bottom edge of finished
coat. Seam bellows of pockets from
the inside to fronts 3/8 inch from
side and bottom serged edges.
Securely tack upper corners of pockets
from the outside through polyester
twill stay pieces.
36 Make buttonhole tab.
Finished appearance. The sword slit
buttonhole tab shall finish smooth and
flat without distortion. The
stitching shall be uniform and the
buttonhole shall be properly
positioned. The tab shall finish
2-3/8 + 1/8 inches long and 2 + 1/8
inches wide.
a. The buttonhole tab for the sword
slit shall be made of one ply of basic
material and one ply of rayon lining
material.
b. Seam together the lining piece and
301
SSe-2
12-16
A
A
basic material at side and bottom
(show
(silk)
(silk)
edges of tab 3/16 inch. Turn and
finishe
topstitch 1/8 inch from seamed edge.
d seam)
c. Close the top raw edge of tab with
301
SSa-1
12-16
A
A
1/8 inch seam.
(silk)
(silk)
39
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business