MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
39 Interline fronts.
(cont'd)
e. Baste along the shoulder allowing
301
Hopper
room for setting the shoulder pad and
working the fullness towards the
armhole. Baste along front of armhole
approximately 1-1/2 inches from the
edge and continue to baste down the
back edge of the interlining.
40 Sew snap fastener to upper pockets.
Finished appearance. The pocket flaps
shall lie smooth and flat without
distortion when closed.
a. Securely sew one socket snap
101
21 per
A
fastener part to each side edge of the
fastene
upper pockets to properly engage stud
or
r (min)
301
16
A
A
part on flaps. When pocket part is
per
sewn by hand, the stitching shall be
fastene
tacked off with not less than two
or
r
stitches.
Hand
(min)
C
3-4
(silk)
(double
thread)
(not
incl.
tack)
41 Join back and fronts at sides.
Finished appearance. The back and
fronts shall be carefully joined at
the sides without twists, gathers,
puckers, or pleats.
a. Position the back and front, with
301
SSa-1
12-16
A
A
edges even, and join together at the
sides with a 3/4 inch seam.
b. Spread open the side seams and
press flat with a heated pressing
iron.
43
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business