MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
53 Baste yoke lining to back.
a. Position and baste the one piece
301
Hopper
rayon yoke lining to the inside of the
back, along the center pleat and along
the armholes, shoulder and bottom
edges of the yoke.
54 Baste and fell front linings.
a. When necessary, trim the back end
of lower pocket stays away from the
side seam.
b. Fold the front lining, in
Hand
accordance with the notches, forming
or
the chest pleat and baste lengthwise
301
Hopper
along the entire center of pleat.
Baste lining to coat along lower edge
of armhole approximately 1-1/2 inches
from edge, starting at lower end of
chest pleat and continuing to
approximately 2 inches from side seam
of coat and across the bottom finished
edge of lining. The folded edge of
the pleat on the outside of the lining
shall be towards the armhole.
c. Turn under the back edge of the
Hand
front lining matching the lower folded
or
4-6
edge with the side seam and lapping
101
the upper folded edge on the yoke.
Baste the lining to coat from armhole
to bottom finished edge not less than
3/4 inch from folded edge.
d. Fell the turned under portion of
301
SSm-1
6-8
0
0
the front lining to side seam
(silk)
(Silk)
allowance of the fronts and to the
yoke lining with blind stitching 1/4
to 3/8 inch from folded edge.
Stitching shall extend from bottom
finished edge of front lining to the
lower edge of armholes.
55 Trim lining and interlining.
a. Trim the excess coat front
interlining and front lining at the
armhole and front gorge.
b. Trim the yoke lining even with the
back at the neck.
48
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business