MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
63 Set sleeves.
Finished appearance. The sleeves
shall be properly and uniformly set
and the fullness at the armholes shall
be properly distributed. The armhole-
sleeve seam shall finish smooth and
flat without twists, puckers, or
pleats. The armhole shall not be
stretched or distorted due to
pressing.
a. Position sleeves on outside of
coat at the armholes, with back arm
seam of sleeve matching the side back
seam and with notch in top sleeve and
front matching.
b. Join the sleeves to the coat with
301
SSa-1
12-16
A
A
a 3/8 inch seam, distributing fullness
in accordance with good manufacturing
practice and catching the ends of the
shoulder straps in the stitching.
c. Press the entire armhole smooth
and flat with a heated pressing iron
to remove the fullness. Spread open
the upper part of the armhole sleeve
seam from backarm sleeve seam to
approximately midway between shoulder
seam and notch at front edge of
armhole and press smooth and flat with
a heated pressing iron. Care shall be
exercised in pressing armhole seam in
order not to stretch the armhole.
64 Baste armhole lining.
a. Baste around inside armhole,
Hand
positioning yoke lining, shoulder pad,
or
and front lining in place, and
301
Hopper
distributing fullness evenly. Turn
the coat on the outside.
b. Baste around outside armhole
Hand
adjacent to the armhole seam, forcing
or
out the armhole in the basting. The
301
Hopper
basting shall extend from the backarm
seam of the sleeve to the notch in the
front.
52
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business