MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
73 Finish collar.
(cont'd)
c. Fell the lower folded edge of the
Hand
8-10
C
collar lining to the coat from end to
(silk)
end, catching the turned under portion
of the lining at the right end in the
felling. The collar lining may be
basted before felling it to coat.
d. Position the collar tab on the
Hand
8-10
C
inside of collar at the left end, with
(silk)
the collar tab extending approximately
3/4 inch beyond the front end of
collar. Fell the top, back and bottom
raw edges of tab to collar lining.
74 Clean coat.
a. Pull all basting thread, trim and
remove all loose ends of thread, and
remove all spots, stains and tickets,
except one ticket for matching belt to
coat, without injury to the material.
b. Examine buttonholes at front
closure for exposure of coat front
interlining cloth. The exposed
interlining shall be blackened with
indelible ink.
75 Press coat.
Finished appearance. The coat shall
be well pressed throughout with a
heated pressing iron or pressing
machine of a type suitable to obtain
the desired shape and appearance in
accordance with good manufacturing
practices.
a. Press the fronts smooth and flat,
straightening and shaping the front
edges and working the fullness towards
the chest. Care shall be exercised in
pressing the fronts so that the bottom
edges are even.
b. Press the entire collar smooth and
flat.
c. Press the upper fronts on a body
machine, shrinking in and properly
shaping the chest.
57
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business