MIL-DTL-28950C(MC)
5/ Collar sizes represent length of collar in inches measured
from end to end along the center.
6/ Belt length measurement shall be taken along the center from
end to end.
Table III. Pocket and flap measurements. 1/
Size
36-38
40-42
44-46
(Short, Regular, Large, Extra-Large) (inches) (inches) (inches)
Upper pockets and flaps
Length of flap at center point
2-7/8
2-7/8
2-7/8
Length of flap at sides
2-1/8
2-1/8
2-1/8
Width of flap at top edge
4-3/4
5-1/4
5-3/4
Width of pocket at top edge, side to
4-1/2
5
5-1/2
side
4-7/8
5-3/8
5-7/8
Width of pocket at bottom edge, side
to side
6
6-1/4
6-1/4
Length of pocket, top edge to bottom
edge
Lower pockets and flaps
Length of flap at center point
3-3/4
3-3/4
3-3/4
Length of flap at sides
2-1/4
2-1/4
2-1/4
Width of flap at top edge
7-3/4
8-1/4
8-3/4
Width of pocket at top edge, side
7-1/2
8
8-1/2
edge to side edge
10
10-1/2
11
Width of pocket at bottom edge, side
edge to side edge
Length of pocket top to bottom edge:
10-1/2
10-1/2
10-1/2
Short
10-3/4
10-3/4
10-3/4
Regular
11
11
11
Large
11-3/4
11-3/4
11-3/4
Extra Large
1/ Tolerance on all measurements:
+ 1/8 inch.
3.8. Workmanship. The finished coats shall conform to the
quality and grade of product established by this specification.
3.9. Recycled, recovered, or environmentally preferable
materials. Recycled, recovered, or environmentally preferable
materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and
maintenance requirements, and promotes economically advantageous
life cycle costs.
62
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business