MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
66 Fell linings.
(cont'd)
c. Fell the upper back edge of the
Hand
8-10
C
front lining to the yoke lining,
(silk)
placing the stitching over the folded
edge of front lining. Fell the lower
finished edge of front lining. Fell
the lower finished edge of the yoke
lining to the side seam outlet.
d. Fell the yoke lining and
Hand
8-10
C
facing-lining assembly together at the
(silk)
shoulder, placing the stitching over
the folded edge of the yoke lining and
securing the top end of the chest
pleat in the felling.
67 Tack facing and bottom turnup.
a. Fell the ends of the bottom turnup
Hand
8-10
C
to the body of the coat at the vent.
(silk)
b. Fell the back edge of the facings
Hand
8-10
C
to the coat from the bottom to the top
(silk)
edges of the bottom turnup.
68 Finish sword slit.
Finished appearance. The sword slit
shall finish flat and smooth and shall
be firmly stitched and properly
positioned with no puckers, bulges, or
raw edges.
a. Properly position left front
lining and baste to front to hold in
position for cutting of opening for
sword slit tab.
b. Cut opening for sword slit tab in
lining to correspond with opening in
front.
c. Turn under raw edges of lining at
Hand
6-8
C
cut opening and fell folded edge to
(silk)
front
d. Cut 2 inch long opening in sword
slit patch, 3/4 to 1 inch from top
edge. The opening shall be 1 inch on
each side of center of patch.
54
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business