MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
65 Tack armhole and stitch sleeve-head
pads.
Finished appearance. The armhole
shall not be distorted or puckered due
to stitching the sleeve-head pads and
linings at the armhole.
a. Position the sleeve-head pad on
the sleeves with the folded edges of
the pad approximately 1/8 inch back
from the raw edge of the armhole seam,
and with the front end of the pad
matching the notch in the fronts.
b. Stitch the sleeve-head pad to the
301
SSa-1
4-6
24/4
24/4
sleeve from end to end through the
armhole sleeve seam allowance 1/8 inch
from the folded edge of the pad,
catching the armhole end of the stay
for the upper pockets, the front and
yoke linings and the shoulder pad in
the stitching. Continue stitching the
linings around the remainder of the
armhole, trimming away the excess
material.
66 Fell linings.
a. Position the sleeve lining at the
Hand
8-10
C
armhole with back and forearm seams of
(silk)
the sleeves and linings matched. Turn
under the armhole edge of the sleeve
lining and lap the linings on the
outside of the yoke and front linings
at the armhole. Fell the sleeve
lining to the coat around the entire
armhole, placing the stitching over
the folded edge of sleeve lining,
distributing the fullness in
accordance with good commercial
practice, and backstitching the lower
armhole edge from approximately 1-1/2
inches to the front of forearm sleeve
lining seam to the side body lining.
b. Fell the lower corners of the
Hand
8-10
C
front lining to the facings and the
(silk)
front seam allowance, respectively.
53
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business