MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
60 Seam neckline with size label and
hanger. (cont'd)
a. Join facings and the yoke lining
301
SSa-1
10-14
A
A
to the coat at the neckline from
collar notch to collar notch with a
1/4 inch seam. The upper edge of the
size label and the ends of the coat
hanger shall be properly positioned
and caught in the stitching at the
inside center back.
61 Set collar.
Finished appearance. The collar shall
be carefully joined to the coat
without twists, puckers, pleats, raw
edges, or distortion.
a. Mark neckline on the outside 1/2
inch from top edge for proper
positioning of collar.
b. Position the collar with the lower
edge lapped on the outside edge of
coat at the mark.
c. Seam the collar to the coat from
301
LSa-1
10-14
A
A
end to end 1/16 to 1/8 inch from lower
(silk)
(silk)
edge of collar. The stitching shall
not be through the collar lining.
62 Edge stitch coat.
Finished appearance. The coat shall
be uniformly edge stitched with the
same gage as used on flaps and pockets
and without distortion.
a. Topstitch the top and front edges
301
SSe-2
12-16
A
A
of the coat and continue the stitching
front
(silk)
(silk)
along the bottom edge of the coat the
and
width of the facings. Topstitch left
bottom
edge of vent.
edge of
coat
(shows
finishe
d seam)
b. The stitching shall be uniformly
1/8 inch from the edge.
51
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business