MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
47 Baste facing-lining assemblies to
fronts.
a. Position the right and left
Hand
facing-lining assemblies on the
or
outside of the respective fronts and
301
Hopper
baste along the front and bottom edge,
distributing the fullness in the
breast area. The facing shall be held
slightly taut across the bottom edge
of the front while basting.
48 Join facings and fronts with tape.
a. Join the facings to fronts 3/16
301
SSa-1
12-16
A
A
inch from top, front and bottom edges
of coat, with the 3/8 inch wide stay
tape positioned on the interlining
side of fronts and caught in the
stitching.
b. The tape shall be sewn with slight
tension and shall extend from the
collar notch to 1-1/2 to 2 inches from
side seams at the bottom of the coat.
c. Fell inside edge of 3/8 inch wide
103
SSm-1
4-6
A
stay tape to the coat front
interlining from top end of tape to
the bottom edge of interlining.
d. Press the front edges smooth and
flat with heated pressing iron or
pressing machine, removing the
fullness.
e. Remove all basting stitches. Trim
lower and upper front corner of the
facings and extend the cut for collar
notch to the seam for proper turning.
f. Spread open the front-facing seam
from the collar notch to the bottom
edge of the coat and press smooth and
flat with a heated pressing iron.
49 Baste front and bottom edge of coat.
a. Turn the facing-lining assemblies
to the inside of the fronts, working
out the corners completely. Turn the
bottom of the coat, lapping the facing
on the bottom turnup, and working out
the front corner completely.
46
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business