MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
36 Make buttonhole tab.
(cont'd)
d. Make a vertical eyelet-end,
Button-
60 per
B
F
taper-bar type buttonhole, cut 5/8
hole
button-
(silk)
(silk)
inch long, in center of tab with the
hole
inside edge of the buttonhole eyelet
(incl.
placed 1/2 to 5/8 inch above bottom
tack)
edge of tab. The buttonhole shall be
well worked over gimp to fit a 22-line
sewing hole button. The purling of
the buttonhole shall be on the lining
side of the tab.
37 Make sword slit and attach buttonhole
tab (see Figure 9).
Finished appearance. The sword slit
shall finish without bulges or
excessive bulkiness.
All parts shall
be securely fastened and properly
positioned. The flap shall be
securely attached and properly
positioned to cover slit properly.
a.
Mark left front for 2 inch long
sword slit in waist seam. The back
end of the sword slit shall be 1/2 to
5/8 inch in front of underarm seam.
b. Topstitch the left front, 1/16
301
OSf-1
12-16
A
A
inch below waist seam, through the
(silk)
(silk)
seam allowance, for a distance of 2
inches, starting 1/2 to 5/8 inch in
front of the underarm seam. The
stitching shall be through the
allowance of the waist seam but not
through the pocket stay. The lower
pocket stay material shall be trimmed
away from the sword slit opening.
c. Tack across waist seam at each end
301
SSa-1
12-16
A
A
of the topstitching to prevent seam
(silk)
(silk)
from opening when sword slit is cut.
The tacks shall be 1/8 inch long, 1/16
inch on each side of seam.
40
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business