MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
56 Baste shoulder pad.
a. Insert shoulder pad between
Hand
Hopper
interlining and chest padding of coat
or
fronts in line with the armhole edge
301
and securely tack the pad to the
interlining and chest padding only.
57 Seam shoulders.
Finished appearance. The shoulder
seam shall be uniformly stitched and
the fullness on the backs shall be
properly placed in order that the
shoulders may be properly shaped. The
shoulder seam shall finish without a
distorted appearance.
a. Join the fronts and back together
301
SSa-1
10-14
A
A
at the shoulders with a 3/8 inch seam,
working in the proper fullness on the
backs, in accordance with good
manufacturing practice.
b. Spread open the shoulder seam and
press flat, holding the shoulder short
and exercising much care in the
pressing in order not to effect a
distorted appearance in the finished
seam. The pressing shall be
accomplished with a heated pressing
iron or pressing machine over a
suitable block.
58 Set shoulder straps.
Finished appearance. The shoulder
straps shall be properly positioned
and uniformly stitched to the coat
without twists, puckers, pleats, or
other distortion. On the finished
coat, the straps shall be 2-3/8 + 1/8
inches wide at the armhole seam and
shall taper to 1-3/4 + 1/8 inches at
eyelet end of the buttonhole.
49
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business