MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
17 Tack cuff to sleeve.
(cont'd)
b. Tack the raw edge of the cuff to
103
SSm-1
4-6
A
the body of the sleeve with blind
stitching.
c. On the finished coat, the length
of the cuff shall be 3-1/4 + 1/4
inches at the front and back creased
edges and 6 + 1/4 inches at the point.
18 Seam sleeve linings.
Finished appearance. The sleeve
lining shall be uniform in appearance,
uniformly stitched an shall finish
smooth and flat without twists,
gathers, puckers or pleats. The seams
shall start and finish evenly.
a. Position the top and under sleeve
301
SSa-1
10-14
A
A
lining pieces in accordance with
notches on pattern and join at the
forearm and backarm, respectively,
with a 3/8 inch seam.
19 Assemble sleeve and sleeve lining.
Finished appearance. The sleeve
linings shall be properly positioned
and seamed to sleeve without twists,
gathers, puckers or pleats.
a. Properly position the sleeve
lining on the sleeve with the upper
edge of the lining extended 3/4 to 1
inch beyond the armhole edge of the
sleeve.
b. Seam sleeve lining to top sleeve,
301
SSa-1
6-8
A
A
backarm and forearm seam allowance
respectively, commencing approximately
4 inches above finished bottom edge of
sleeve and extending to approximately
6 inches below armhole edge at the
backarm and approximately 4-1/2 inches
below armhole edge at the forearm.
20 Fell turnup of sleeve lining; press
sleeves.
Finished appearance. The sleeve
linings shall not be short, tight or
twisted at bottom of sleeves.
28
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business