MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
9 Make upper and lower pocket flaps.
(cont'd)
e. Press the flaps smooth and flat
with a heated pressing iron or
pressing machine.
f. Mark and trim top edge of flaps so
that in the finished coat the length
of the flaps at center point and sides
shall conform to measurements shown in
Table III.
g. Join the raw edges of the lining
504
EFd-1
8-10
A
A
and flap together with overedge
or
stitching.
505
EFd-1
8-10
A
A
h. Make a vertical eyelet end,
Button-
38 per
B
F
square- bar type buttonhole, cut 3/4
hole
button-
(silk)
(silk)
inch long through the center of each
hole
pocket flap, with the inside edge of
(min)
the eyelet 5/8 + 1/8 inch above the
(not
center point.
incl.
bartack
)
i. Securely bartack the end of
Bartack
21 per
A
A
buttonholes, and trim the ends of the
bartack
(silk)
(silk)
gimp.
(min)
10 Make upper pockets.
Finished appearance. The binding
shall be uniformly stitched and shall
not be tight or full causing puckers,
gathers, or pleats; the basic material
and both edges of binding shall be
securely caught in the stitching. The
pleats shall be vertically centered
and the folded side edges of the
pleats shall be parallel. The pockets
shall be uniform in shape and size in
accordance with the pattern.
a. Form a vertical box pleat on the
outside center of upper pockets with a
heated creasing machine. The pleat
shall be 1-1/2 inches wide.
b. Secure the pleat with a row of
301
SSe-1
10-14
A
A
stitches 1/16 inch from top and bottom
edges, respectively. Trim the lower
corners of the pockets.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business