MIL-DTL-28950C(MC)
c.
Adhesive type tickets which show discoloration or leave
traces of paper or adhesive mass to the material upon removal of
the tickets.
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1 Cutting.
a. Cut coats in strict accordance
with patterns furnished.
b. Cut all materials in the direction
indicated by the directional lines on
the patterns. The straight of the
cloth indicates the warp direction.
c. Cut all wool or polyester/wool
parts of the coat, including belts,
from one piece of basic material,
except the following parts may be cut
from ends, but when so cut, the parts
shall harmonize with the shade of
coat: under ply of shoulder straps,
sword slit buttonhole tab, belt loops
and belt keeper may be banded 1 inch
wide.
d. Cut fronts, yoke, collar and vent
lining parts of the coat and facing
for inside pocket from one piece of
rayon lining material. All other
rayon lining parts may be cut from
ends.
When pairs of sleeve linings
are cut from ends, the shade of the
linings shall match each other. The
belt lining shall be cut 2-1/4 inches
wide, and the belt fastener shall be
cut 1-5/8 inches wide. Bias binding
shall be cut 3/4 inch wide for edge of
bottom turnup, back edge of facings,
and for edges of seam allowances and
1-1/8 inches wide for top edge of
pockets.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business