MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
7 Make optional one-piece belt (see
Figure 7). (cont'd)
f. Topstitch the belt uniformly 1/8
301
A
OSf-1
12-16
A
inch from top and bottom folded edges
(top
(silk)
(silk)
and
and seamed end, turning in the square
-or-
-or-
bottom
end of the belt 1/4 inch and catching
edges)
the turned-in portion of the
A
A
stitching. The seam of the belt shall
SSe-2
(silk)
(silk)
(b)
finish off center.
(pointe
d end)
SSc-1
(square
end)
g. The finished width of the belt
shall be 1-3/4 (+1/16, -1/8) inches.
The finished length of the belt for
each size coat shall be as shown in
Table II.
h. Make a horizontal eyelet end,
Button-
60 per
B
F
taper-bar type buttonhole, cut 5/8
hole
button-
(silk)
(silk)
inch long, in the center of the belt.
hole
The inside edge of the eyelet end of
(incl.
the buttonhole shall be 1/2 to 5/8
tack)
inch from the buckle end of the belt.
The buttonhole shall be well worked
over the gimp to fit a 22-line sewing
hole button. The purling of the
buttonhole shall be on the outside of
the belt.
i. Mark the location for sewing one
22-line sewing hole button to the
underside of the belt. The button
shall be sewn to the belt with the end
of the stitching securely tacked.
j. Securely sew the button at the
Hand
6 per
24/4
mark on the belt to properly engage
button
buttonhole in buckle end. On the
(double
finished belt, the button shall be
thread)
3-5/8 + 1/8 inches from square end of
belt.
k. Trim the ends of the stitching and
remove all loose ends of thread from
the belt. Remove all spots and stains
from the belt without injury to the
material.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business