MIL-DTL-28950C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
15 Join cuffs to sleeve.
(cont'd)
a. Fold the cuff lengthwise at the
301
SSa-1
12-16
A
A
point with wrong side out. Tack the
point 1/8 inch from the raw edges.
Turn cuff completely working out the
point.
b. Turn under the upper edge of the
101
4-6
cuff, forming the finished curved edge
in accordance with the shape of the
pattern. Press smooth and flat with a
heated pressing iron or pressing
machine, creasing the upper edge of
cuff, or the cuff may be basted
instead of pressed.
c. Mark the sleeve in accordance with
the pattern for positioning the cuffs,
with notch matching the forearm seam
line and with the lower raw edge of
the sleeve and marker even.
d. Position the cuffs at the mark on
301
LSd-1
12-16
A
A
the sleeve and seam uniformly 1/8 inch
(silk)
(silk)
from the upper edge of cuff.
16 Seam sleeve at backarm.
Finished appearance.
The backarm
seam shall finish smooth and flat
without twists, gathers, puckers or
pleats and shall start and finish
evenly.
a. Join the top sleeve to the under
301
SSa-1
12-16
A
A
sleeve at the backarm with a 3/8 inch
seam, catching the ends of the cuffs
in the seam.
b. Spread open the sleeve and cuff
seams and press flat with a heated
pressing iron. Trim ends of cuff if
necessary.
17 Tack cuff to sleeve.
a. Turn the cuff outlet to the
Hand
inside, in accordance with notches,
or
against the bottom end of sleeves, and
101
4-6
baste along the turned edge of cuff.
27
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business