MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
12
Make watch pocket (style A only).
(cont'd)
b. Position the bearer over one
301
LSd-1
12-16
A
40/3
ply of pocket material with the
upper edges even. Turn under the
lower edge of the bearer and seam
to the pocket, 1/8 inch from the
folded edge. A serged edge does
not have to be turned.
c. Properly position front and
301
SSe-2
12-16
40/3
40/3
back pieces of the pocket with
(a)
edges even and join together at the
side and bottom edges with a 1/4
inch seam. The stitching shall
extend from notch to notch at upper
side edges.
d. Turn the pocket forcing out the
301
SSe-2
12-16
40/3
40/3
seamed edges. Topstitch the pocket
(b)
uniformly 1/4 inch from seamed
edges.
13
Make and join waistband lining.
Finished appearance. The waistband
lining shall measure not less than
2 inches wide in the finished
trousers. The waistband linings
may be pieced provided the seam
finishes flat and there is no more
than one piecing on each pair of
trousers. The waistband stabilizer
may be 1 inch shorter than the
waistband lining at seat seam. In
the finished trousers, the
waistband lining shall not be
exposed beyond the top edge of the
waistband.
a. The waistband
lining-interlining assembly shall
consist of any one of the lining
materials specified in 3.3.2.1 and
one ply of interlining cotton
buckram cloth specified in 3.3.3.
b. Overlap the lining on the
301
LSa-1
6-10
50/3
50/3
buckram interlining 1 inch (see
or
operation 1.j) and stitch 1/8 to
401
LSa-1
6-10
50/3
50/3
3/16 inch from edge of lining.
or
101
LSa-1
6-10
50/3
50/3
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business