MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
16
Attach hip pocket, flaps and label.
Finished appearance. The pockets
shall finish smooth and flat
without bulkiness, bulges or other
distortions on the outside of the
finished trousers. The stitching
shall be uniform and secure. The
pocket openings and flaps shall be
in proper alignment.
a. Position pocket flaps on the
301
LSg-2
10-14
50/3
50/3
outside of the back in line with
(a)
the mark as indicated by pattern,
with the pocketing on the under
side. Stitch through all plies
3/16 to 1/4 inch from the mark.
b. Position the hip pocket cord on
301
SSe-2
10-14
50/3
50/3
the outside of trousers in line
(a)
with the mark and stitch through
all plies 3/16 to 1/4 inch from the
mark.
c. Cut pocket opening through the
301
SSe-1
10-14
0
0
back and pocket, simultaneously.
(shows
or
or
The opening shall not extend beyond
finished
50/3
50/3
the ends of the flap. Turn the
seam)
cord piece through the opening and
raise stitch, forming a 1/8 to 3/16
inch cord edge at lower edge pocket
opening.
d. Turn under the lower raw edge
301
LSd-1
10-14
50/3
50/3
of cord facing and seam pocketing
or
1/16 to 1/8 inch from folded edge.
301
LSbj-1
10-14
50/3
50/3
When cord facing is cut on selvage,
(selvage
)
the edge need not be turned under.
e. Turn the pocketing wrong side
301
SSae-2
10-14
50/3
50/3
out, matching notches with pocket
or
(a)
opening, and stitch sides 3/16 to
401
SSae-2
10-14
50/3
50/3
1/4 inch from raw edges. The
(a)
stitching may extend across the
bottom folded edge.
f. Turn pocketing, forcing out
301
SSae-2
10-14
50/3
50/3
corners and seamed edges. Fold and
or
(b)
10-14
50/3
50/3
stitch the pocket 1/4 to 3/8 inch
301
OSf-1
from the side edges. Continue to
stitch along the bottom edges. The
stitching may extend across the
bottom folded edge.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business