MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
2
Replacement of damaged parts.
a. At time of cutting, replace any
part containing damages such as
holes or seriously weakening
defects such as smashes, multiple
floats and slubs, likely to develop
into holes, as classified in
MIL-STD-1488.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into holes, scissors or
knife cuts, tears, holes, mends or
burns and large exposed drill
holes.
3
Shade marking.
a. Mark or ticket the component
parts to ensure a uniform shade and
proper assembly throughout the
trousers, except those parts
specified in operation 1.c, which
may be cut from ends and need not
match each other. Tickets shall
conform to 3.6.4.
4
Overedge stitch trousers.
Finished appearance. The overedge
stitching shall be securely caught
in the fabric. The raw edge of the
overedged material shall be
properly trimmed.
a. Overedge stitch the inseam and
502
EFd-1
6-10
70/2
70/2
outseam of front of trousers, also
or
the fly edge of right front. The
503
EFd-1
6-10
70/2
70/2
overedge stitching of the inseam of
or
front shall extend from bottom of
504
EFd-1
6-10
70/2
70/2
trouser to fly notch. The overedge
stitching of the outseam of fronts
shall extend from bottom notch of
side pocket to bottom of trouser
leg.
b. Overedge stitch inseam and
502
EFd-1
6-10
70/2
70/2
outseam of back part of trousers.
or
The side pocket stay piece, with
503
EFd-1
6-10
70/2
70/2
the bottom edge turned up, may be
or
attached to the outseam in the
504
EFd-1
6-10
70/2
70/2
overedge operation.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business