MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
9
Make right fly.
Finished appearance. The right fly
shall finish without bulkiness,
twists, puckers or pleats.
a. The fly shall consists of one
ply of basic material and lining.
b. Stitch right fly and right fly
301
SSe-2
10-14
50/3
50/3
lining together 3/16 to 1/4 inch
or
(a)
from front edge. The seam shall
401
SSe-2
10-14
50/3
50/3
(a)
extend from the bottom end of fly
to the upper edge of fly.
c. In the finished trousers, the
upper end of the lining shall
extend to top of waistband over the
waistband lining, and the lining
extension piece at the lower end
shall not extend less than 1/2 inch
beyond inseam.
d. Make a 5/8 inch long horizontal
Button-
48 min
0
0
eyelet-end taper bar type
hole
stitche
buttonhole 3/8 inch below and
s per
horizontal with the waistband seam
button-
hole
1/2 inch in from edge of right fly
(incl.
piece. The buttonhole shall be
tack)
well worked over gimp to fit a
22-line button. The purling of the
buttonhole shall be on the
underside of the fly.
10
Assemble right and left flies.
Finished appearance. The flies
shall be of even length where they
join the crotch seam. The fastener
parts shall be set so that there is
no twisting or puckering when fly
is closed.
a. Position flies with notches at
301
SSa-1
10-14
50/3
50/3
lower end matching. Seam slide
or
fastener tape to back edge of right
503
fly, stitching 1/4 inch from edge.
or
When 301 stitch is used, the edge
504
of the right fly shall be serged.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business