MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
16
Attach hip pocket, flaps and label.
(cont'd)
l. Raise stitch the joining seam
301
-
10-14
0
0
of the lower edge of pocket opening
or
or
through back of trousers and cord
50/3
50/3
facing, only. Raise stitch the
back at upper edge of pocket
opening through all plies, closing
the top of the pocket. Securely
tack both ends of pocket opening.
m. The depth of the pockets shall
be 5-3/4 to 6-1/4 inches when
measured on the inside of pocket
from top edge of cord facing to
bottom.
n. The finished pocket opening
(after bartacking) shall not exceed
the hip pocket flap.
o. On the finished trousers, the
pocket flaps shall be 2-1/4 + 1/4
inches at center measured from seam
to center point.
17 Attach watch pocket.
Finished appearance. The completed
watch pocket opening shall not be
stretched and the pocket material
shall not be exposed on the
outside.
a. Position the pocket on the
301
SSe-2
12-16
40/3
A
outside of the right front at the
(a)
notches for the pocket opening.
Seam the front part of the pocket,
only, to the front of trousers 3/8
inch from the top edge, from notch
to notch.
b. Extend depth of notches for the
301
SSe-2
12-16
A
40/3
opening to the seam. Turn the
(b)
pocket to the inside of the front
of trousers and edgestitch the
pocket opening 1/16 to 1/8 inch
below the top edge.
c. Securely tack the ends of the
301
SSa-1
12-16
A
A
pocket opening through front of
trousers and front and back of
pocket.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business