MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
24
Press waistband.
a. Turn out front end of left and
right waistband, forcing out the
corners. Turn waistband lining to
inside and press along the top edge
of waistband. Trousers waistband
lining shall not be exposed beyond
top edge of waistband.
25
Attach hooks and eyes.
Finished appearance. In the
finished trousers, when hook and
eye is engaged, the closure shall
not bulge, pucker or twist.
a. Position the hook at the center
(1/4 inch off center tolerance) of
the left waistband with the rolled
edge of hook aligned with the slide
fastener scoops. Attach hook to
left waistband through a suitable
reinforcement.
b. Position the eye at the center
of the right waistband aligned with
slide fastener scoops and to
correspond with hook and left
waistband. Attach eye to right
waistband through a suitable
reinforcement.
26
Stitch pockets to lower edge of
waistband.
a. Stitch top end of all pockets
301
SSa-1
10-14
50/3
50/3
to waistband seam allowance with
or
pockets properly positioned and
101
smoothed out.
27
Finish right and left fly.
Finished appearance. The top
corners of the right and left flies
shall be completely forced out and
shall not be bulky. The stitching
of the left fly shall be uniformly
stitched from edge of fly. The
seam joining the left fly to the
front shall not be exposed on the
outside. The flies shall be smooth
and flat without twists, puckers or
excessive fullness.
26
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business