MIL-DTL-28919B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
c. Cut all component parts for the
trousers from the same piece of
basic material to insure a uniform
shade throughout the trousers. The
following parts may be cut from
ends but when cut from ends the
parts shall harmonize with the
shade of trousers: belt loops,
pocket bearers and facings.
d. Cut the pockets on the straight
of the material in accordance with
patterns. Cutting of pockets in
the direction of the filling is not
permitted except when it is
essential for economical use of the
material.
e. Cut stripping for belt loops of
sufficient width to comply with the
requirements of operation 11.
f. Cut the right fly lining in
accordance with the directional
lines on the pattern.
g. Cut left fly interlining, hip
pocket flap linings, and stays for
side pockets in the warp or filling
direction.
h. Cut crotch lining parts so
that, when folded, the fold will be
on the bias, and one of the inseam
sides is in the warp direction.
i. Cut the waistband linings and
interlinings on the bias and of
sufficient width to comply with
operation 13.
j. Cut waistband stabilizer of
sufficient length to comply with
operation 13.
k. The waistband lining may be
commercial type comprised of the
lining, interlining and waistband
stabilizer materials specified.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business