MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
1
Make eyelets in right front.
2
Finished appearance. The eyelets
shall be worked with the purling on
the outside of the front, and shall
finish with 1/8 inch diameter
opening. All stitches shall be
securely caught in the fabric. The
center of the eyelets shall be
uniformly 1/2 inch minimum and 5/8
inch maximum from the finished front
edge of the vest and shall be evenly
spaced.
a. Mark the right front for the
location of four eyelets for
removable insignia buttons in
accordance with marks on patterns.
b. Make an eyelet at each mark on
Eyelet
21 per
A
A
the right front, through the front
eyelet
(silk
(silk
and interlining.
)
)
1
Make eyelet opening.
3
a. Position lining for eyelet
301
SSe-2
10-14
A
A
opening on outside of right front
(a)
(silk
(silk
facing with edge of facing and
)
)
lining even, and with notches
matching. Stitch lining to facing
from upper to lower notches with a
3/8 inch seam.
b. Extend the depth of the notches
301
SSe-2
10-14
A
A
up to the lining facing seam. Turn
(b)
the lining to the underside of the
facing and edgestitch 1/16 to 1/8
inch from the seamed edge.
c. Switch the front raw edge of the
301
SSa-1
10-14
A
A
lining and facing together 1/8 to
(silk
(silk
3/16 inch from the raw edge. Trim
)
)
excess lining if necessary.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business