MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
2
Finish front.
0
Finished appearance. Fronts shall
finish smooth and flat without
distortion. The edge stitching
shall be of uniform width without
twisting, pleating or puckering and
shall finish smooth and flat.
a. Edgestitch the vest along the
301
SSe-2
12-16
A
A
front, bottom and armhole 1/16 inch
(b)
(silk
(silk
from the seamed edges.
)
)
b. Remove all basting and press the
edges of lapel, front and bottom
edges of the vest smooth and flat
with a heated pressing iron or
pressing machine, removing the
fullness. Turn lapel back over the
front and crease along the breakline
smooth and flat.
2
Finish front.
(cont'd)
0
c. Tack the upper and lower rounded
301
SSa-1
12-16
A
A
corners of the lapel to the fronts,
(silk
(silk
through all plies, in line with the
)
)
edge stitching for a distance of
approximately 1 inch.
2
Join back lining to fronts.
1
Finished appearance. The seams
shall be carefully joined without
twists, puckers or pleats. The
seams shall start and finish evenly.
The back lining shall be over the
fronts. The lower joining seam for
the back lining shall not be visible
on the outside of the vest.
a. Position right and left fronts
between the plies of the respective
back lining with edges even, notches
matching and lower edge of front
abutting the lower joining seam of
back lining.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business