MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
9
Set welt and hanging pocket.
Finished appearance. The welt and
hanging pocket shall be set to the
fronts smooth and flat and without
twists, gathers, puckers, raw edges
or distortion.
a. Mark the fronts for the position
of the pockets in accordance with
the marks on the pattern. Mark the
welt 1 + 1/8 inch from the folded
edge for proper seaming to fronts.
b. Position welt on the outside of
fronts with the mark on the welt and
front matching and with the raw edge
towards the upper edge of front.
c. Seam and welt to the fronts at
301
SSa-1
10-14
A
A
the mark through the interlining.
d. Position one ply of pocket
301
SSa-1
10-14
A
A
lining on outside of front with one
edge under the raw edge of the welt
and abutting the welt seam. Stitch
the pocket lining to the front
through the interlining 3/8 inch
from the raw edge of the lining.
e. Cut the pocket opening midway
between the seams and tongue notch
each end of the opening. The
opening shall not extend beyond the
ends of the welt.
f. Turn the pocket lining and the
raw edge of welt through the pocket
opening, with the folded edge of the
welt towards the top of the front.
g. Position the other ply of pocket
301
SSa-1
10-14
A
A
lining on the inside of front even
with the raw edge of welt. Seam
together 3/8 inch from the raw edge.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business