MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
1
Cutting.
(cont'd)
f. The use of drill holes is
prohibited.
2
Replacement of damaged parts.
a. Replace at time of cutting any
part containing damages such as
holes or seriously weakening defects
such as smashes, multiple floats,
and slubs likely to develop into
holes.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into a hole, scissor or
knife cuts, tears, mends or burns.
3
Shade marking.
a. Mark all component parts cut
from one piece of basic and lining
materials to insure uniform shade
and size throughout the vest.
b. The use of tickets with metal
fastening devices is prohibited on
the rayon material.
c. Adhesive type shade ticket, when
used, shall be adhered to the inside
of the vest.
4
Labeling.
Finished appearance. The labels
shall be correctly positioned and
securely attached.
a. Position the identification
301
LSbj-1
10-14
A
A
label in front lining approximately
1 inch from the finished side seam
and approximately 4 inches from
armhole and seam on all sides 1/8
inch from each edge.
b. The size label shall be centered
301
LSbj-1
10-14
A
A
on the inside right back 1-1/2 to 2
inches below the neck and seamed 1/8
inch from all edges.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business