MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
a. Fold the front lining in
301
SSa-1
10-14
A
A
accordance with the notches in the
pattern and stitch across the width
of the pleat 1/8 to 3/16 inch from
each end.
b. Press the pleat smooth and flat
with a heated pressing iron.
1
Join back and seam darts.
6
Finished appearance. The back seams
shall start and finish evenly and
shall be smooth and flat without
gathers, puckers or pleats.
a. The inside and outside back,
shall each be made from two plies of
rayon lining.
b. Properly position the respective
301
SSa-1
10-14
A
A
backs with edges even and seam
together along the center back from
the neck to the bottom edge with a
3/8 inch seam.
c. Fold the darts, matching the cut
301
SSa-1
10-14
A
A
edges. Stitch along the entire
length of the darts, beginning 3/8
inch from the raw edge at the bottom
end and tapering to a point at the
top end.
d. Press the center seams and darts
flat with a heated pressing iron or
pressing machine.
1
Stitch adjustment straps to back.
7
Finished appearance. The straps
shall be in proper alignment and
shall be stitched to the back
without puckers, wrinkles or other
distortion. The seamed side of the
straps shall face the outside of the
back lining. In the finished vest
the bottom edge of the straps shall
be 3 to 3-1/4 inches above the
finished bottom edge of the back
lining. The rounded end of the
straps shall overlap no less than
1-3/4 inches for attaching buckle
and fastening.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business